On-site measurement

TO GET IT RIGHT FIRST TIME

The success of the project depends to a large extent on the quality of the measurements taken on your site: this is the real technical starting point for the design and validation of the proposed solution, for successful implementation right from the "first go". It is therefore important that the quantity surveyor is able to observe the machines in operation as well as in maintenance.

Scanning the most complex points

APC uses Creaform's "GoSCAN 3D" technology to scan the most delicate points on your machines and production lines. In this way, we import the actual surfaces of your equipment directly into our 3D modeling for a design as close as possible to reality.

A design that takes your use cases into account

When we take measurements, we take into account every possible use case. During this phase, our quantity surveyors endeavor to understand not only the established procedures, but also the habits of the operators, so as to improve the acceptability of the solutions implemented. If necessary, this approach enables us to identify and correct risky behavior when using the machines.